1 month ago - A value of dance in education which can be a rich medium for exploring the customs, attitudes, history and living circumstances of people of other lands.
1 month ago - A network administrator is analyzing the differences between an EIGRP hold timer and EIGRP hello interval. What statement is valid about EIGRP hello and hold timers?
1 month ago - The wildcard mask that is used to advertise exactly the network 192.168.160.0 with subnet mask 255.255.240.0 is
1 month ago - Which command will limit the bandwidth that is used by EIGRP process 1 to 20%?
1 month ago - OSPFv2 is classless by design; therefore, it supports IPv4 VLSM and CIDR.
1 month ago - Routing changes trigger routing updates (no periodic updates). It uses the SPF algorithm to choose the best path.
1 month ago - Which multicast address does an EIGRP-enabled router use to send query packets?
1 month ago - Which bandwidth value is used when calculating the EIGRP metric of a route?
1 month ago - Which protocol number is used to indicate that an EIGRP packet is encapsulated in an IP packet?
1 month ago - are used by routers to facilitate the exchange of routing information between routers.
1 month ago - Valid for both non-Normally distributed data and Normally distributed data
1 month ago - If you are using interval or ratio scales you use _________________________________.
2 months ago - Qualitative data are variables that cannot be ordered in a logical or natural way.
2 months ago - of a switch refers to the number of ports available on a single switch.
2 months ago - are typically deployed in the core and distribution layers of an organization's switched network.
2 months ago - allows the switch to deliver power to a device over the existing Ethernet cabling.
2 months ago - Displays all interfaces with IPv4 addressing information and interface and line protocols status.
2 months ago - Which switchport mode Puts the interface into permanent trunking mode and negotiates to convert the neighboring link into a trunk link?
2 months ago - is used for initial configuration or when a network connection is unavailable.
2 months ago - Each of the following pairs of folk dance steps can be performed in combination except for the?
3 months ago - Ballet gained its popularity in this period, and it is believed to be the main core of every single dance style.
3 months ago - Plato immensely gave importance to dance in education as stated in education on the laws.
3 months ago - Dances during prehistoric times have not yet been fully recorded. It was only during the ancient period where ____ are believed to be the first people to dance because of the discovery of dancing figures in rock shelters and caves.
3 months ago - Same as jogging, a 30-minute dancing can burn fats between 130 and 250 calories.
3 months ago - Dance in this period increased as a court amusement and later transformed into professional entertainment.
3 months ago - A period of "dance fever" wherein the young and old alike were not limited to express their emotions through dance.
3 months ago - Which PAgP mode mode places an interface in a passive negotiating state in which the interface responds to the PAgP packets that it receives, but does not initiate PAgP negotiation?
3 months ago - During the implementation of Spanning Tree Protocol, all switches are rebooted by the network administrator. What is the first step of the spanning-tree election process?
3 months ago - Which STP port role is adopted by a switch port if there is no other port with a lower cost to the root bridge?
3 months ago - What value determines the root bridge when all switches connected by trunk links have default STP configurations?
3 months ago - After the election of the root bridge has been completed, how will switches find the best paths to the root bridge?
3 months ago - When PVST is running over a switched network, which port state can participate in BPDU frame forwarding based on BPDUs received, but does not forward data frames?
3 months ago - An administrator is troubleshooting a switch and wants to verify if it is a root bridge. What command can be used to do this?
3 months ago - It involves the application of specific statistical techniques to disciplines in biology such as population genetics, epidemiology and public health.
3 months ago - What is a number or attribute computed for each member of a population or a sample?
3 months ago - The characteristic of population based on all units is called parameter while the measure of sample observation is called statistic.
3 months ago - When the number of units in a population are uncountable, and so it is impossible to observe all the items of the universe
3 months ago - It is used to make predictions or comparisons about a larger group (a population) using information gathered about a small part of that population.
3 months ago - It is the study of how to collect, organize, analyze, and interpret numerical information from data.
3 months ago - Statistics is only the science of uncertainty and not the technology of extracting information from data.
3 months ago - Example of this are number of episodes of respiratory arrests or the number of re-intubations in an intensive care unit.
3 months ago - Which of the following is NOT a good way to make a prompt more effective?
4 months ago - What query should be used in order to display the lastname and salary of all employees whose department_id = 60 or job_id like ‘_T%’. Format the salary to be 15 character long, left padded with ‘$’ as special character. Label the column Salary.
4 months ago - Based on the given SELECT statement below what would be the possible output? SELECT FIRSTNAME, SALARY, LPAD(SALARY * 0.10 + SALARY – 100, 8, ‘$’) AS BONUS FROM EMPLOYEES WHERE DEPARTMENT_ID NOT IN (10, 110, 50 AND SALARY=17000;
4 months ago - SELECT LASTNAME,SALARY, RPAD(SALARY,4,’@’) FROM EMPLOYEES WHERE SALARY BETWEEN 4000 AND 9000 LASTNAME LIKE ‘%S’;
4 months ago - Get the average salary; Group the data per job_id; Get only job_id with a keyword “REP”; and Apply having clause, which the max salary per job_id is greater than 5000.
4 months ago - What query should be used in order todisplay the firstname in capitalized format rename the column as pangalan whose job_id is equal to ‘SA_REP’.
4 months ago - Which of the following is the correct query that counts the number of ST_CLERK job_id? Rename the column as “Total no. of ST_CLERK”.
4 months ago - Count the Job_id; Apply where condition whose lastname ends with letter ‘N’; Group the job_id; and Apply having clause of employees having average salary that is greater than 10000.
4 months ago - SELECT COUNTDISTINCT(MANAGER_ID) AS "NO. OF MANAGER_ID" FROM EMPLOYEES;